Dnf-controls GC-32 GPIO Controller Manuel d'utilisateur Page 2
- Page / 14
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
Page 2 of 14
32 GPOs and GPIs. The client is responsible for establishing and maintaining the
connection. In the event of a loss of connection, the client is responsible for re-
establishing the connection and re-configuring the GC-32, if required.
The GC-32 has two programmable operating modes. In Mode 1, all GPIs and GPOs are
allocated to the port 50001 connection and identified as GPI 1 to GPI 32, and GPO 1 to
GPO 32. In Mode 2, GPIs 1 – 16 and GPOs 1 – 16 are allocated to the port 50001
connection and GPIs 17 – 32 and GPOs 17 – 32 are allocated to the port 50002
connection. The operating mode of the GC-32 may be changed at any time. Changing
the operating mode will clear any pending GPI change of state notifications.
The GC-32 can be configured to accept a connection from any IP address on port 50001
or 50002. Or, it can be configured to accept a connection from only the specific IP
address for each port indicated on the GC-32’s Remote Device Assignment web page.
FRONT VIEW
REAR VIEW
DEFAULT SETTINGS
DEFAULT ETHERNET CONFIGURATION
IP Address: 192.168.10.217
Subnet Mask: 255.255.255.0
Gateway: 192.168.10.1
Use the GC-32’s System Configuration web page to change the IP address, subnet, and
gateway. See section at the end of this document.
DEFAULT OPERATING MODE
The default operating mode is Mode 1. Use the Set Operating Mode command
described below to change the operating mode.
- GC-32 GPIO CONTROLLER 1
- Programming Manual 1
- Page 3 of 14 3
- PROTOCOL DESCRIPTION 3
- Page 4 of 14 4
- GC-32 COMMAND SET 4
- Page 5 of 14 5
- Page 6 of 14 6
- Page 7 of 14 7
- Page 8 of 14 8
- CONFIGURATION WEB PAGES 8
- Page 9 of 14 9
- Page 10 of 14 10
- CONNECTORS- GPI, GPO 10
- Page 11 of 14 11
- Page 12 of 14 12
- Page 13 of 14 13
- Page 14 of 14 14
- LIMITED WARRANTY 14
Produits connexes et manuels pour Équipement Dnf-controls GC-32 GPIO Controller
(2 pages)Chloride Desk POWER 300 podręczniki
Instrukcje obsługi i podręczniki użytkownika dla Zasilacze bezprzerwowe (UPS) Chloride Desk POWER 300.
Dostarczamy 1 pdf podręczników Chloride Desk POWER 300 do pobrania za darmo według typów dokumentów: Instrukcja Użytkownika
Commentaires sur ces manuels